Bronco Multi-Function LED High-Mount Rear Roof Lights for 2021–Present Ford Bronco (Non-Sport)

Specifications:    

Configuration: Pair (Left & Right Modules)
Operating Voltage: 12V DC
Functions: Red Running Light, Red Brake Light, White Reverse Light, Amber Turn Signals
Mounting: Automotive-Grade 3M Adhesive Tape
Wiring: Plug-and-Play Tail Light T-Harness Connector
Waterproof Rating: IP66
Compatibility: 2021–2026 Full-Size Ford Bronco 2-Door & 4-Door (Excludes Bronco Sport)

⚠️ FITMENT & COMPATIBILITY WARNING

• Fits: 2021–2026 Full-Size Ford Bronco (2-Door & 4-Door models).

• Does NOT Fit: Ford Bronco Sport.

Product Description

• Upgrade your rear lighting setup with this 2-piece high-mount LED roof spoiler light kit. Positioned along the upper rear roofline, these integrated modules improve chase visibility and rear signaling without interfering with rear window or tailgate operation.
• Multi-Mode Signaling: Combines low-glow red running lights, high-output red brake lights, bright white reverse lamps, and sequential amber turn signals.
• No-Drill 3M Mounting: Secures to the vehicle body above the rear glass using pre-applied automotive-grade 3M adhesive tape. No drilling, cutting, or mounting brackets needed.
• Concealed Weatherstrip Routing: Wiring tucks neatly into the factory rear window rubber seal for a clean, hidden install without exposed cables.
• Plug-and-Play Tail Light T-Harness: Plugs inline directly behind the factory tail light assembly. Zero wire cutting or splicing required.
• IP66 Sealed: Built to resist high-pressure water spray, dust storms, automated car washes, and harsh off-road elements.

🛠️ Step-by-Step Installation Guide 

1. Surface Prep: Clean the upper rear mounting surfaces with rubbing alcohol and allow to dry thoroughly.

2. Mount Lights: Peel the protective film from the pre-applied 3M backing, align each light module above the rear glass, and apply firm, even pressure.

3. Route Wires: Open the rear window and press the wiring harnesses into the factory rubber weatherstripping channel down toward the tail light cavity.

4. Plug-and-Play Connection: Remove the tail light access screws and trim panel, unplug the factory connector, insert the included pass-through T-harness inline, and reinstall the tail light.